HEX Energy

Checking sign-in…

Job Setup:Set once. Attaches to every form you submit.
← Back to Portal

Aerial Lift Pre-Shift Inspection

Scissor Lift / Boom Lift / MEWP Daily Inspection

OSHA 1926.453 / 1910.67 REQUIRED
πŸ“‹ Inspection Information
πŸ” Pre-Operation Inspection
ANSI/OSHA Requirement: Aerial lifts must be inspected before each shift. Do not operate if any safety defects are found.
Documentation & LabelsPending
βœ“ Operator manual available
βœ“ Capacity/load chart visible
βœ“ Safety/warning decals legible
βœ“ Annual inspection current
βœ“ OSHA/ANSI compliance labels
βœ“ PASS
βœ— DEFECTS
Base & FramePending
βœ“ Frame - no cracks or damage
βœ“ Welds - no cracks or defects
βœ“ Outriggers/stabilizers functional
βœ“ Mounting hardware secure
βœ“ No visible structural damage
βœ“ PASS
βœ— DEFECTS
Tires & WheelsPending
βœ“ Tire condition - adequate tread
βœ“ Tire inflation - proper pressure
βœ“ No cuts, bulges, or damage
βœ“ Wheel lugs tight
βœ“ No missing or damaged wheels
βœ“ PASS
βœ— DEFECTS
Hydraulic SystemPending
βœ“ Hydraulic fluid level adequate
βœ“ No hydraulic leaks
βœ“ Hoses - no damage or wear
βœ“ Cylinders - no damage or leaks
βœ“ Fittings secure
βœ“ PASS
βœ— DEFECTS
Lift MechanismPending
βœ“ Scissors/boom - no damage
βœ“ Pivot pins secure
βœ“ Extension cylinders functional
βœ“ Slide pads adequate (scissor)
βœ“ Boom sections extend/retract smoothly
βœ“ PASS
βœ— DEFECTS
Platform / BasketPending
βœ“ Platform floor - no damage
βœ“ Guardrails secure
βœ“ Mid-rails in place
βœ“ Toeboards secure
βœ“ Gate/entry chain functional
βœ“ Extension deck secure (if equipped)
βœ“ PASS
βœ— DEFECTS
Ground ControlsPending
βœ“ Emergency stop functional
βœ“ All controls labeled
βœ“ Controls return to neutral
βœ“ Override key/switch present
βœ“ Emergency lowering functional
βœ“ PASS
βœ— DEFECTS
Platform ControlsPending
βœ“ All controls functional
βœ“ Emergency stop functional
βœ“ Controls labeled and legible
βœ“ Foot switch functional (if equipped)
βœ“ Drive/steer controls respond properly
βœ“ PASS
βœ— DEFECTS
Electrical / BatteryPending
βœ“ Battery charged adequately
βœ“ Battery connections secure
βœ“ No corrosion on terminals
βœ“ Wiring - no damage or exposure
βœ“ Charger functional
βœ“ PASS
βœ— DEFECTS
Safety DevicesPending
βœ“ Tilt alarm/indicator functional
βœ“ Descent alarm functional
βœ“ Load sense system (if equipped)
βœ“ Limit switches functional
βœ“ Travel alarm functional
βœ“ PASS
βœ— DEFECTS
PPE AvailablePending
βœ“ Hard hat available
βœ“ Safety harness available (boom lifts)
βœ“ Lanyard available and in good condition
βœ“ Harness inspection current
βœ“ Anchor point identified
βœ“ PASS
βœ— DEFECTS
Complete all sections above to see overall status
βœ… Certification & Actions
Yes
No
Yes
No
N/A
Yes
No
Yes
No (Scissor)
Yes - Ground conditions, overhead hazards, slopes checked
No
AnthroSafeβ„’ Field Driven Safety
Β© 2026 SLP Alaska, LLC
Back to Portal / Volver al Portal